a Karimzadeh - Professor, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, 16846-13114, Iran
M.R Ayatollahi - Professor, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, 16846-13114, Iran
A.R Bushroa - Senior lecturer, Department of Mechanical Engineering, Faculty of Engineering, University of Malaya, Kuala Lumpur, 50603, Malaysia

In this study the hyperelastic behavior of Bis-GMA was determined by nano-indentation experiment and finite element (FE) simulation method. For this purpose, the nano - indentation experiment was performed on Bis-GMA specimen according to its common method. A three dimensional hyperelastic FE model was employed to simulate the nano-indentation procedure. The uniaxial compression test was also done on Bis-GMA samples to measure the required material parameters for the FE model.Results of the nano-indentation experiment indicated that stress relaxation occurs in the Bis-GMA specimen when the indenter is held at the maximum indentation depth. The stress relaxation modulus in term of holding time was calculated from the results of nano-indentation experiment. Comparing the load-displacement curve obtained from the FE simulation with corresponding values of the nano-indentation experiment revealed good agreement when using a second order polynomial model

Hyperelastic behavior, nano-indentation experiment, Bis-GMA biopolymer, FE simulation, stress relaxation modulus