amir h. roohi - Department of Mechanical Engineering, Faculty of Engineering, Tarbiat Modares University, Tehran, I.R. Iran
h Moslemi Naeini - Department of Mechanical Engineering, Faculty of Engineering, Tarbiat Modares University, P.O.Box ۱۴۱۱۵/۱۴۳, Tehran, I.R. Iran
m Hoseinpour Gollo - Department of Mechanical Engineering, Shahid Rajaee Teacher Training University (SRTTU), Lavizan, Tehran, Iran
j Shahbazi Karami - Department of Mechanical Engineering, Shahid Rajaee Teacher Training University (SRTTU), Lavizan, Tehran, Iran

Laser forming is a thermal forming process which uses laser beam irradiation to produce the desired final forms. In this article, the effect of temperature gradient across Al 6061-T6 aluminum sheets on bending angle is studied. Input parametersincluding laser power, scan velocity, beam diameter, and sheet thickness are the effective process parameters which influence the temperature gradient. Thus, a set of81 numerical simulations based on a full factorial design with varying parameters is carried out and temperature gradient across the sheet thickness is measured. Effects of each input parameter on temperature gradient are determined using analysis ofvariance. Also, an equation is derived which predicts the temperature gradient for any arbitrary input parameter. The validity of the equation is done by comparingactual and predicted results. Numerical simulation is validated by experimental tests, which show a very close agreement. Finally, the effects of temperature gradient for three different sheet thicknesses on a final bending angle are derived. Resultsdemonstrate that increase in temperature gradient across sheet thickness leads to increase in bending angle.

Laser forming process, Aluminum alloy sheet, Temperature gradient, Bending angle, Process parameters