Majid Heydari - Department of Water Science and Engineering, Faculty of Agriculture, Bu-Ali Sina University, Hamadan, Iran.
Jalal Sadeghian - Department of Civil Engineering, Faculty of Technical and Engineering, Bu-Ali Sina University, Hamadan, Iran
Saeid Shabanlou - Department of Water Engineering, Kermanshah Branch, Islamic Azad University, Kermanshah, Iran

Manning roughness coefficient is one of the most important parameters in designing water conveyance structures. Unsuitable selection of this coefficient brings up some mistakes. This research aims to present a method to determine the Manning roughness coefficient based on a combination of optimization algorithm of simulated annealing (SA) with gradually varied flow equations. Therefore, in a lab rectangular flume of 12 m, 60 cm and 65 cm in length, width and height with fixed channel bed slope of 0.0002, nine series of water level profiles were carried out. Then, an objective function based on observed and calculated water level gradient was defined to decide on manning roughness coefficient while it was minimized with simulated annealing optimization method. The values of objective function parameters were discussed by sensitivity analysis and the most optimal objective function was obtained. To measure the accuracy of coefficient obtained, Statistics indices of R2, Root mean square error (RMSE), Mean bias error (MBE), d were used. The results showed that manning roughness coefficient has a great accuracy.

Manning roughness, Simulated annealing algorithm, Gradually varied flow, Nonlinear optimization