Effect of Segmental Joint on Internal Forces in Tunnel Lining under Seismic Loading by Numerical Method
محل انتشار: مجله معدن و محیط زیست، دوره: 11، شماره: 3
سال انتشار: 1399
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 257
فایل این مقاله در 15 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JMAE-11-3_007
تاریخ نمایه سازی: 21 اردیبهشت 1400
چکیده مقاله:
Although segmental tunnel linings are often used for seismic areas, the influence of segment joints on the segmental lining behavior under seismic loading has not been thoroughly considered in the literature. This paper presents the results of a numerical study investigating the effects of the rotational, axial, and radial joint stiffness of the longitudinal joints on the structural forces in segmental tunnel lining under seismic loading. A ۳D finite element method is adapted to establish elaborate numerical models of the segments. The validity of the numerical model was tested by comparing the results obtained with the well-known analytical methods presented by Wang and Penzien. The results demonstrate that by increasing the rotational stiffness of the segmental joint, the bending moment increases. When the rotational stiffness ratio is less than ۰.۵, the positive and negative bending moment variations are more. The numerical modeling results show the variations in the bending moment and the difference between the positive and negative bending moment values increased by increasing the acceleration of seismic loading. Moreover, it is significant for the values. By increasing the rotational stiffness ratio of the segmental joint, the axial force ratio decreases. By increasing the axial and shear stiffness ratio of segmental joint, the variations in the bending moment and axial force in segmental lining is not significant and is ignorable in designing segmental lining.
کلیدواژه ها:
نویسندگان
Gh.H. Ranjbar
Faculty of Mining Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran
K. Shahriar
Faculty of Mining and Metallurgy Engineering, Amirkabir University of Technology, Tehran, Iran
K. Ahangari
Faculty of Mining Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :