Investigation of Microstructure and Mechanical Properties of Al-۶۰۶۱ Tubes Processed by Tubular Channel Angular Pressing Process Having Trapezoidal Channel Geometry
محل انتشار: مجله شکل دهی مواد، دوره: 9، شماره: 2
سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 135
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJMF-9-2_005
تاریخ نمایه سازی: 10 اردیبهشت 1401
چکیده مقاله:
The many benefits of ultra-fine grained (UFG) tubes in the industry have led researchers to devise methods to increase the strength of tubes. Tubular channel angular pressing (TCAP) process is a new severe plastic deformation (SPD) technique to produce UFG tubes. In this research, at first, one pass of tubular channel angular pressing process with trapezoidal channel geometry is applied on Al-۶۰۶۱ samples. Then, mechanical properties such as yield strength, ultimate strength, hardness, and microstructure of the TCAPed samples are compared with the initial ones. In addition, effective strain and stress, processed load and deformation geometry during different stages of the tubular channel angular pressing process were investigated by finite element modeling. Finally, the results of the analytical model with finite element simulation were compared. It should be noted that the trapezoidal channel geometry has been used due to the high strain homogeneity and low force required for this channel geometry compared to other channel geometries. The microstructural results showed that the grain size of the initial samples was reduced from ۹۲ µm to ۷۸۵ nm in the TCAPed samples. The results of compression test showed that the yield strength and ultimate strength of the samples increased by ۹۰% and ۵۲%, respectively. The hardness of processed samples was also increased by ۵۶% compared to the initial ones.
کلیدواژه ها:
نویسندگان
A. Aghababaei
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran
M. Honarpisheh
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :