Effects of Porous Parameters on the Aerodynamic Noise of the Blowing Device of Guardrails
سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 112
فایل این مقاله در 14 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JAFM-15-4_018
تاریخ نمایه سازی: 18 خرداد 1401
چکیده مقاله:
To solve the problem of the strong noise generated in the galvanizing process on the surface of the guardrail board, optimal design of the outlet structure of the blowing device is carried out according to the sound absorption and noise reduction theory of microperforated plates. The aerodynamic characteristics and aerodynamic noise analysis of the blowing device are investigated by large eddy simulation with dynamic grid technology. The oblique surface of the outlet is processed with blind holes, and then the influence of blind holes on the aerodynamic noise of the blowing device is explored, including different shapes, porosities and depths. The spectral study reveals that when the guardrail board just enters the blowing device, there is greater noise compared to other working conditions. The place with the highest noise sound pressure level (SPL) is at the outlet of the blowing device at the monitoring point of R=۱ m and the direction of ۹۰°. The SPLs of the monitoring points at ۰° and ۱۸۰° are smaller than those in other directions, while the SPL distribution of the monitoring points in other directions is relatively even. Compared with the original blowing device, the best noise reduction performance is achieved when the blowing device has cylindrical holes, with a porosity of ۱۰% and a hole depth of ۳ mm. The noise reduction value reaches up to ۲۸.۴ dB. In addition, an aerodynamic noise test was carried out on the blowing device in the corrugated board galvanizing workshop to demonstrate the correctness of the results of the numerical simulation.
کلیدواژه ها:
نویسندگان
M. H. Zhang
Department of Mechanical and Electronic Engineering, Shandong University of Science and Technology, Qingdao, ۲۶۶۵۹۰, China
H. J. Shi
Department of Mechanical and Electronic Engineering, Shandong University of Science and Technology, Qingdao, ۲۶۶۵۹۰, China
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :