The effects of heat treatment on the mechanical properties of wear resistant Cr-Mo Steel
محل انتشار: سومین کنفرانس بین المللی عملیات حرارتی مواد
سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,993
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICMH03_054
تاریخ نمایه سازی: 21 تیر 1391
چکیده مقاله:
The effects of heat treatment on the properties of wear-resistant Fe-0.7C-2.3Cr-0.4Mo-0.5Si alloy steel which is used to make the liner of rolling mill were researched. The results show that when quenching temperature is lower than 940 °C , the hardness increases with the increase of temperature, and when quenching temperature is higher than 960 °C , the hardness decreases with the increase of temperature. As quenching temperature is lower than 940 °C , the effect of quenching temperature on the impact toughness is not obvious. When quenching temperature is higher than 960 °C, impact toughness decreases with the increase of temperature. When tempering temperature is higher than 400 °C , the hardness begins to decrease obviously. After tempering at 300 °C , the best wear resistance was obtained. According to the service condition of rolling mill liner, the Cr-Mo Steel is quenched from 940-960 °C and tempered at 300-320 °C.
کلیدواژه ها:
نویسندگان
Mahyar Mohammadnezhad
Research and Development Unit of Isfahan Casting Industres (ICI)
Vahid Javaheri
Department of Materials Engineering,Iran University of Industries & Mines
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :