The Failiur Analysis of Nb-Microalloyed δ-TRIP Steel

سال انتشار: 1397
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 105

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJMSEI-15-3_004

تاریخ نمایه سازی: 1 اسفند 1401

چکیده مقاله:

The relation between microstructure and the fracture mechanisms of δ-TRIP steel with different Nb-content has been investigated using complementary methods of light microscopy, SEM, EDS, EBSD, X-ray phase analysis and tensile test. The results revealed a close dependency between the presences of constitutive phases i.e. ferrite, bainite, retained austenite and martensite and the mode and characteristics of fracture. All samples revealed almost different fractography pattern which could be associated to the effect of Nb microalloying element. The different fractography patterns were consisted of dimple rupture, riverside and Wallner lines pattern. The proportion of the cleavage fracture in comparison of dimple rapture increased by increasing the Nb-content due to the increase of primary martensite in the microstructure.

نویسندگان

S. Gholami Shiri

Department of materials science and engineering, school of engineering, Shiraz University, Shiraz, Iran

Y. Palizdar

Nanotechnology and Advanced Materials Department, Materials and Energy Research Center, Karaj, Iran

A. Jenabali Jahromi

Department of materials science and engineering, school of engineering, Shiraz University, Shiraz, Iran

F. de Monlevade

Department of Metallurgical and Materials Engineering, Polytechnic School, University of São Paulo, São Paulo, Brazil

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Cai, Z., et al., Unique impact of ferrite in influencing ...
  • Srivastava, A.K., et al., Effect of heat treatment on microstructure ...
  • Tsuchiyama, T., et al., Microstructure and mechanical properties of a ...
  • Li, Z., Z. Cai, and R. Misra, The critical factors ...
  • S.Gholami SHIRI, S. A. Jenabali JAHROMI, Y.PALIZDAR, M. BELBAS, JOURNAL ...
  • Hausmann, K., et al., The influence of Nb on transformation ...
  • Song, Y.Y., et al., Austenite in transformation-induced plasticity steel subjected ...
  • A. Grajcar, H. Krztoń. Effect of isothermal bainitic transformation temperature ...
  • Wei, H.-l., et al., Hot deformation behavior of two C–Mn–Si ...
  • Alkan, G., D. Chae, and S.-J. Kim, Effect of δ ...
  • Feng, Q., et al., Microstructures and mechanical properties of hot-rolled ...
  • Dan, W., et al., The effect of strain-induced martensitic transformation ...
  • Lacroix, G., T. Pardoen, and P.J. Jacques, The fracture toughness ...
  • Wang, H., et al., Microstructural evolution and mechanical properties of ...
  • Zakerinia, H., A. Kermanpur, and A. Najafizadeh, Color metallography; a ...
  • E. B. J. M. A Mertens, "Microstructure and mechanical properties ...
  • R. W. HERTZBERG, DEFORMATION AND FRACTURE MECHANICS OF ENGINEERING MATERIALS, ...
  • Handbook, A. S. M. "volume ۱۲: fractography." ASM International Materials ...
  • نمایش کامل مراجع