Effect of Surface Roughness on Brinell Hardness and Load-Displacement Curves using a Macro Indentation
محل انتشار: ماهنامه بین المللی مهندسی، دوره: 36، شماره: 5
سال انتشار: 1402
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 168
فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJE-36-5_008
تاریخ نمایه سازی: 17 اردیبهشت 1402
چکیده مقاله:
Surface roughness significantly affects the scattering of load-displacement curves and the measurement of mechanical properties by the macro-scale indentation. Many mechanical properties such as modulus of elasticity, yield stress, strain hardening exponent, and hardness can be determined using the indentation results, which are the information obtained from the load-displacement curve. Reliable parameters of the load-displacement (P-h) curve are employed to estimate the mechanical properties. The inaccurate P-h curve leads to a misestimation of material properties. Ignoring the surface roughness might be a source of error in the indentation results. In this paper, the effects of surface roughness on the P-h curve of macro spherical indentation and Brinell hardness number (BHN) were studied. The range of roughness with minimal effect on indentation results was obtained. The surface roughness of ۲ and ۱۲ microns was created on the experimental samples using the electrical discharge machining (EDM) process. The finite element simulations were performed with different surface roughnesses. The results showed that roughness affected both the P-h curve and hardness values in different indentation depths and various indenter sizes. It was observed that with increasing the Rq roughness, the P-h curve level and hardness value decreased and that with increasing the indentation depth, the effect of roughness on hardness decreased as well. The neumerical results showed a good agreement with the results of experiments.
کلیدواژه ها:
نویسندگان
A. Karbasian
Mechanical Engineering Department, Bu-Ali Sina University, Hamedan, Iran
M. Shirazi
Mechanical Engineering Department, Bu-Ali Sina University, Hamedan, Iran
A. H. Mahmoudi
Mechanical Engineering Department, Bu-Ali Sina University, Hamedan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :