Residual Stress and deformation analysis and prediction of SLM manufacturedsamples with the Inherent Strain method
سال انتشار: 1401
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 56
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME19_003
تاریخ نمایه سازی: 19 اردیبهشت 1402
چکیده مقاله:
The residual stress developed during manufacturingprocesses has an important role on the success of the samplesmanufacturing. The laser powder bed fusion method ofadditive manufacturing has been widely used in differentindustries to produce prototypes as well as the geometricalcomplex parts. Prediction of the residual stress of the samplesis an important challenge for these parts. The inherent strainis used in the present research to simulate the manufacturingmethod to fabricate the tensile test samples. The numericallymanufactured sample is tested and the obtained stress-straincurve is compared with the experimental results
کلیدواژه ها:
نویسندگان
Ali Sadegh
MSc student, Mechanical Engineering School, Shiraz University, Shiraz, Iran
Amir Khosravifard
Associate Professor,
Ali Nayebi
Professor,