Comparison of Plastic Anisotropy and Crystallographic Texture Evolution of Aluminum ۱۱۰۰ Between ۹۰° and ۱۳۵° ECAE Processes
محل انتشار: مجله شکل دهی مواد، دوره: 10، شماره: 1
سال انتشار: 1402
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 66
فایل این مقاله در 13 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJMF-10-1_004
تاریخ نمایه سازی: 28 خرداد 1402
چکیده مقاله:
A rolled sheet of aluminum ۱۱۰۰ was processed by two ECAE dies with inner corner angles of ۹۰° and ۱۳۵°. The samples were processed using route A up to ۴ and ۱۰ passes in ECAE ۹۰° and ۱۳۵°, respectively. The mechanical behaviors of initial and processed materials were evaluated by nano-indentation and compression tests carried out at three different orthogonal directions, at room temperature. Crystallographic texture evolution during two different ECAE processes has been also studied. A considerable reduction in mechanical anisotropy is displayed for processed materials compared to the initial material by nano-indentation tests. Though there is appreciable progress in mechanical isotropy for processed materials by ۱۳۵° ECAE, compared to the ۹۰° case. Studying crystallographic texture evolutions reveals that ECAE ۱۳۵° is more capable than ECAE ۹۰° in the development of cube components; however, the rate of texture evolution is slower in ECAE ۱۳۵°. Dissimilar prominent texture components are also developed by two different ECAE processes.
کلیدواژه ها:
نویسندگان
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :