Optimization of Process Parameters for Catalytic Pyrolysis of Waste Tyre using Reactivated Fluid Catalytic Cracking Catalyst
سال انتشار: 1403
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 71
فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJEE-15-1_002
تاریخ نمایه سازی: 3 شهریور 1402
چکیده مقاله:
This work investigated the optimization of process parameters for catalytic pyrolysis of waste tyre using reactivated spent Fluid catalytic cracking (FCC) catalyst. The waste tyre pyrolysis used design expert software as the optimization tool for this study. A ۳-factor level CCD with ۲۰ experimental runs was used with temperature, time and catalyst as the input parameters while oil yield, density and viscosity were the output variables. Thereafter, an experimental validation of the optimized parameters, which were not among the original experimental runs, was carried out. Pyrolysis was also carried out at the optimized conditions with un-reactivated catalyst and without catalyst to ascertain the contributions of the catalyst and its reactivation. Based on the optimum parameters, ۴۸.۵ wt. % oil (۰.۷۹ g/ml and ۲.۰۵ cSt) was produced with the reactivated catalyst, ۴۳.۴ wt. % (۰.۸۶ g/ml and ۳.۵۲ cSt) was produced with spent catalyst, and ۵۱ wt. % oil (۰.۹۵ g/ml and ۴.۲۴ cSt) was produced without catalyst. The oil yield without catalyst was higher than with reactivated catalyst (R-CAT); but it however had the lowest fuel qualities while oil produced with catalyst in turn had higher quantity and quality compared to oil produced with catalyst. Therefore, the incorporation of density and viscosity of the oil in the optimization of the catalytic pyrolysis of waste tyre enhanced the improvement of yield and quality of the oil produced.
کلیدواژه ها:
نویسندگان
M. Bisong Obi
Department of Chemical Engineering, Ahmadu Bello University, Zaria, Nigeria
A. Abubakar
Department of Chemical Engineering, Ahmadu Bello University, Zaria, Nigeria
S. Yunusa
Department of Chemical Engineering, Ahmadu Bello University, Zaria, Nigeria
F. Mohammed
Department of Chemical Engineering, Ahmadu Bello University, Zaria, Nigeria
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :