Numerical Modeling of the Amount and Rate of Sand Produced in Oil Wells

سال انتشار: 1400
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 43

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JPSTR-11-31_004

تاریخ نمایه سازی: 30 آذر 1402

چکیده مقاله:

Nowdays, sand production is one of the most important challenges in the oil and gas industries, making numerous issues. To prevent these problems, it is necessary to use mathematical models to estimate the sand production onset and the amount of sand produced during production. There are generally four methods for predicting sand production: experimental methods that use field observations and well data, laboratory simulations, numerical methods, and analytical methods. In this research, a novel numerical method is proposed to estimate the amount of sand production. First, it is necessary to estimate the onset of sand production using failure criteria and after that, the amount of sand production is estimated. First, to use numerical methods, they must be calibrated by using field data. In this paper, the proposed numerical model is calibrated by using the field observations and well data of a North Sea reservoir. It is used to predict the amount of produced sand that the average relative error of the proposed method was about ۶.۹%. Also, in this model, computable parameters are used to calculate the amount of sand production, which reduces the error of this method. It also shows that this is a practical model. Therefore, the proposed model is reliable, and it can be used to estimate the amount of sand production for subsequent years. The proposed model is developed based on incompressible and slightly compressible fluids; this paper also considers the relationship between porosity and permeability at steady-state conditions. Ultimately, sensitivity analysis on sand production is performed, and the effects of four permeability parameters: uniaxial compressive strength, maximum horizontal stress, and wellbore pressure on sand production are checked.

کلیدواژه ها:

نویسندگان

Ali Zalakinezhad

Department of Chemical and Petroleum Engineering, Sharif University of Technology, Tehran, Iran

Saeid Jamshidi

Department of Chemical and Petroleum Engineering, Sharif University of Technology, Tehran, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Mohammed A (۲۰۱۲) Comparative study of sand control methods in ...
  • Rahmati H, Jafarpour M, Azadbakht S, Nouri A, Vaziri H, ...
  • Nouri A, Vaziri H, Belhaj H, Islam M R (۲۰۰۷) ...
  • Fahimifar A, Karami, M, Tohidi A (۲۰۱۸) A review of ...
  • Almedeij J H, Algharaib M K (۲۰۰۵) Influence of sand ...
  • Okereke N, Ogbuka V, Izuwa N, Kara F, Nwogu N, ...
  • Talaghat M, Esmaeilzadeh F, Mowla D (۲۰۰۹) Sand production control ...
  • Willson S, Moschovidis Z A, Cameron J R, Palmer I ...
  • Healy J C, Martin J, McLaury B, Jagroop R (۲۰۱۰) ...
  • Mahmud H B, Leong V H, Lestariono Y (۲۰۲۰) Sand ...
  • Raeis Abadi Z, Nadri Pari M, M Parvazdavani (۲۰۱۶) Predicting, ...
  • Bahmani A R (۲۰۱۷) Sand production control in sandstone reservoirs ...
  • Mohamad-Hussein A, Ni Q (۲۰۱۸) Numerical modeling of onset and ...
  • Qiu K, Marsden R, Alexander J, Retnanto A, Abdelkarim O ...
  • Veeken C, Davies D R, Kenter C J, Kooijman A ...
  • Aborisade O (۲۰۱۰) Practical approach to effective sand prediction, control ...
  • Skj A, Stavropoulou M, Vardoulakis I, Tronvoll J (۱۹۹۷) Hydrodynamic ...
  • Vardoulakis I, Stavropoulou M, Papanastasiou P (۱۹۹۶) Hydromechanical aspects of ...
  • Papamichos E, Stavropoulou M (۱۹۹۸) An erosion-mechanical model for sand ...
  • Papamichos E, Malmanger E M (۱۹۹۹) A sand erosion model ...
  • Wang Y, Xue S (۲۰۰۲) Coupled reservoir-geomechanics model with sand ...
  • Fjar E, Holt R M, Raaen A M, Horsrud P ...
  • Oyeneyin B (۲۰۱۷) Integrated sand management for effective hydrocarbon flow ...
  • Pham S T (۲۰۱۷) Estimation of sand production rate using ...
  • Hommel J, Coltman E, Class H (۲۰۱۸) Porosity–permeability relations for ...
  • Darvishpour A, Seifabad M C, Wood D A, Ghorbani H ...
  • Mirabbasi S M, Ameri M J, Biglari F R, Shirzadi ...
  • Papamichos E (۲۰۲۰) Analytical models for onset of sand production ...
  • Lin C, Zou D S (۲۰۲۱) Formulation and verification of ...
  • Zamani M A M, Knez D (۲۰۲۱) A new mechanical-hydrodynamic ...
  • Al-Ajmi A M, Zimmerman R W (۲۰۰۶) Stability analysis of ...
  • نمایش کامل مراجع