Axial Compression Capacity of Cold Formed Steel C-Channel Single Stud Section
محل انتشار: هفتمین کنگره ملی مهندسی عمران
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,250
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
NCCE07_1502
تاریخ نمایه سازی: 16 مهر 1392
چکیده مقاله:
Non-linear finite element analyses were carried out to evaluate the axial compression capacity of a C-channel cold formed steel section using software ANSYS. Different structural characteristics including: material nonlinearity, geometric imperfection, residual stresses and perforations are taken into account. Then, the numerical models were compared with some standard-recommended analytical methods including: Traditional effective width method, direct strength method. Also the results verified against the experimental outputs. The results show that there is a good agreement between the numerical simulations and the test results which indicate that the finite element analysis can be used effectively to predict the ultimate compression capacity of the CFS single studs; whereas the direct strength method has a considerable error of around 26%. In addition, compared to the experimental results, the simultaneous use of effective width method and CUFSM, concludes a rational result
کلیدواژه ها:
نویسندگان
Mehran Zeynalian
Assistant Professor, The University of Isfahan, Isfahan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :