Experimental Determination of forming limit diagram of 5083 aluminum alloy sheet produced by equal channel angular rolling process
محل انتشار: کنفرانس دو سالانه بین المللی مکانیک جامدات تجربی
سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 502
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
WMECH03_040
تاریخ نمایه سازی: 26 شهریور 1395
چکیده مقاله:
In the present research, effect of Equal channel angular rolling(ECAR) as one of the severe plastic deformation process on the structure of 5083 aluminum alloy sheets have been investigated. By applying the rolling process can be structural with uniformly grain size and even improvement in mechanical properties along with appropriate formability achieved. The aim of this study was to determine the formability of sheets produced by the ECAR process at room temperature. For this purpose, firstly the micro-hardness and Mechanical properties were extracted after each pass. It was observed that by each passing, continual improvement in yield strength and hardness were made while elongation at break was reduced. At the 3th pass, the yield strength, ultimate strength and hardness values respectively increased by 75%, 15% and 73%. Moreover, the forming limit diagrams (FLDs) were determined experimentally by using the Nakazima test. The obtained results showed that after 3th pass the level of the FLDs moves downward which means a reduction in the forming limits of ECARed samples.
کلیدواژه ها:
نویسندگان
H. R. Rahimi
Undergraduate Student, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran
M Sedighi
Professor, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran
R Hashemi
Assistant Professor, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran