DEFORMATION BEHAVOR OFTWP STEELDURING SMPLE SHEAREXTRUSION (SSE)
سال انتشار: 1390
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 418
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
UFGNSM03_020
تاریخ نمایه سازی: 10 تیر 1396
چکیده مقاله:
In the present study, an Fe-22Mn-3Si-Al TWIP steel is processed through simple shear extrusion (SSE) as a severe plastic deformation method. Dies with two maximum distortion angles of 30 (SSE-30) and 45 (SSE-45) are designed and constructed. The deformation behavior at different locations from the entrance to the exit of the deformation channel is investigated. The dislocation density and the crystallite size at the selected positions are also determined by the X-ray diffraction using the modified Williamson-Hall method. Results show that the hardness reaches to its maximum at the middle of both SSE-30 and SSE-45 channels (by a factor of about 3.3, and 4.1, respectively) compared to the annealed state. The hardness decreases slightly at the second half of the deformation channel. A similar trend is observed for dislocation density from the entrance to the exit channel. One pass of SSE-30 and SSE-45 leads to the crystallite sizes of about 710 nm and 500 nm, respectively.
کلیدواژه ها:
نویسندگان
E. BAGHERPOUR
M.Sc. student, Department of Materials Science and Engineering, School of Engineering, Shiraz University, Shiraz, Iran
M. REIHANLAN
Assistant Professor, Department of Materials Science and Engineering, Faculty of Engineering, Shahid Chamran University, Ahvaz, Iran
R. EBRAHIMI
Associate Professor, Department of Materials Science and Engineering, School of Engineering, Shiraz University, Shiraz, Iran