Morphological and physical study of Cu-Ni sintered porous wicks used in heat pipes and fuel cells

Recently, the use of renewable energies has increased to environmental pollution, limitation of fossil energy resources and energy security One of the means that enable us to use such energies is fuel cells (FC). However, there are many problems in the commercialization of FC from an economically and operation perspective. One of the most important problems is heat management. New heat pipes arebeing developed for this purpose. A heat pipe is made from a porous coat on a base metal. In this study, a Cu-Ni porous layer with a thickness of ~300μm was considered as the coating on a Cu-Ni base metal with two kinds of powder (mixed and ball milled). The morphology and physical properties of the coatings, such as porosity, permeability and effective thermal conductivity, were investigated. Thebest permeability was obtained for the base metals coated with powder which was ball milled for 6 hours. Thermal conductivity of samples increased (by 9.5%) when using ball milled powder. Porosity of coated samples decreased with ball milled powder in comparison to mixed powder.