Analytical Buckling Analysis of The Isotropic Thin Plate With Circular/Rectangular Cutout
محل انتشار: کنفرانس دو سالانه بین المللی مکانیک جامدات تجربی
سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 627
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
WMECH03_121
تاریخ نمایه سازی: 26 شهریور 1395
چکیده مقاله:
In this paper buckling of simply supported rectangular isotropic plates with circular or rectangular cutout is investigated. The plate is considered as a thin plate and, based on the classical plate theory; an analytical solution for this plate subjected to unidirectional in-plane compression is developed. The displacement field is assumed by the form of Fourier series, which satisfies the boundary condition of a simply supported plate. The buckling load is computed using Rayleigh-Ritz method. The presented method could be applied to the rectangular plate with an arbitrary eccentric cutout shape. In this paper the numerical results are illustrated for square plate with central circular or square hole, and the effect of the cutout shape is investigated. In order to validate the obtained results, a FEM analysis is also carried out by implementing ABAQUS CAE software. In addition, the results are compared with those available in the literatures. The fairly good agreement among the results is observed which can demonstrate the capability and versatility of the presented method. The results show that increasing the size of the cutout decrease the buckling load dramatically. It is also observed that for the holes with the same area, the shape of the cutout has no significant effect on the critical bucking load of the perforated plate
کلیدواژه ها:
نویسندگان
A Talezadehlari
PhD student, Faculty of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran
GH Rahimi
Professor, Faculty of Mechanical Engineering, Tarbiat Modares University, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :